Studs are threaded on both ends and act as a guide pin when aligning gaskets, covers, etc. With the part in place, the washer and nut is installed without the concern for the part being shifted out of alignment. Designed to hold the flange to the turbocharger.
Due to engineering standards, some parts are updated or changed and are assigned a new part number. Previous part number was 6672947. This part is the direct replacement.
Fits the following Bobcat equipment: 442, 863, 864, 873, 883, A220, A300, S250, T200
Parts can vary depending on your serial number. Check the Bobcat Online Parts Catalog to ensure the correct part for your equipment.
442, 863, 864, 873, 883, A220, A300, S250, T200
WARNING: This product can expose you to chemicals including lead and lead compounds, mineral oils, and phthalates which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov